NEC Univerge SV8300 - [Cm93] Prime Line

3-557 NWA-033623-001 Rev.8.1
91ch3006.fm
COMMAND CODE
TITLE:
PRIME LINE
93
FUNCTION:
This command is used to assign the prime line to a station line or a trunk line on a Multiline Terminal.
The prime line is the line seized when the Multiline Terminal user goes off-hook or presses the speaker
key.
PRECAUTION:
Any one station line or trunk line provided on the Multiline Terminal can be assigned as Prime Line.
ASSIGNMENT PROCEDURE:
DATA TABLE:
MY LINE
+
ST
++
93
++
DE
EXE
+
NUMBER
(1-8 digits)
DE
STATION
NUMBER
(1-8 digits)
TRUNK
NUMBER
(4 digits)
NOTE: My Line number is registered to Prime Line number automatically when a station number
is assigned by CM10 after setting Fixed pattern and Programmable pattern of Multiline
Terminal by CM04 Y=00>02.
See Fixed pattern and Programmable pattern
MY LINE
NUMBER
SETTING DATA
RELATED
COMMAND
DATA MEANING
X
XXXXXXXX
X
XXXXXXXX
Station number/Virtual Line number
NOTE: Any station number or Virtual Line
number can be assigned to the
Prime Line.
A single-line telephone cannot be
assigned as the Prime Line.
CM10, CM11
D000
D511
Trunk number CM30 Y=02, 03, 18
~
~
~
APRIL/16/2010
CM93