NEC Univerge SV8300 - [Cm31] Mfc;Mf-Ani Trunk Data

3-270 NWA-033623-001 Rev.8.1
91ch3003.fm
COMMAND CODE
TITLE:
MFC/MF-ANI TRUNK DATA
31
FUNCTION:
This command is used to assign the attribute data to MFC/MF-ANI trunk lines.
PRECAUTION:
None
ASSIGNMENT PROCEDURE:
DATA TABLE:
ST
EXE
++ ++
31Y
2ND DATA
DE
1ST DATA
(1-2 digits) (1-2 digits)
++
DE
: Default
Y
1ST DATA 2ND DATA
DATA MEANING DATA MEANING
0 0 Nation code 01
03
04
15
NONE
Australia
North America
Asia/Africa/Europe/Latin America/
Middle East/Russia
New Zealand
As per CPU blade
Nation code
[For EU]
05 Austria/Belgium/Denmark/Germany/Italy/
South Africa/Spain/Sweden/Switzerland/
The Netherlands/UK/Brazil/China/Interna-
tional/Latin America/Asia
NOTE 1: Default of CM31 Y=0>0 depends on each nation code of the CPU program.
For Australia/NZ: 01
For North America: 03
For Asia/Africa/Europe/Latin America/Middle East/Russia: 04
NOTE 2: In case of EU, the default of CM31 Y=0>0 is same as North America (nation code 03).
Therefore, you must set the nation code to 05 by this command.
NOTE 3: A-law/µ-law setting is decided in the following order.
1. Setting of CM04 Y=10-59
2. Setting by CPU
Continued on next page
RESET
RESET
APRIL/16/2010
CM31