NEC Univerge SV8300 - [Cmb1] Traffic Measurement

3-602 NWA-033623-001 Rev.8.1
91ch3007.fm
COMMAND CODE
TITLE:
TRAFFIC MEASUREMENT
B1
FUNCTION:
This command is used to measure traffic data of outgoing/incoming trunk calls and to display the data
on CAT or PCPro.
PRECAUTION:
When the system is reset, all commands of CMB1 are initialized.
ASSIGNMENT PROCEDURE:
DATA TABLE:
ST
EXE
++ ++
B1Y
DE
1ST DATA
(1-5 digits)
++
DE
2ND DATA
(1-8 digits)
: Default
Y 1ST DATA 2ND DATA
No. MEANING DATA MEANING DATA MEANING
0 Setting of traffic
measurement condition
0 Traffic Measurement
Mode
0
1
2
3
4
No measurement
Traffic measurement per
hour
Traffic measurement per
day
Traffic measurement per
hour continuously
Traffic measurement per
day continuously
NOTE: Traffic Measurement start time and end time settings by CMB1 Y=0>1, 2
are required to set the second data 1 and 2.
1 Setting Start Time for
Traffic Measurement
MMDDHHmm
NONE
MM: Month (01-12)
DD : Day (01-31)
HH : Hour (00-23)
mm : Minute (00-59)
No data
Continued on next page
JUNE/15/2011
CMB1