NEC Univerge SV8300 - [Cm76] Digit Conversion on DID Call

3-483 NWA-033623-001 Rev.8.1
91ch3005.fm
COMMAND CODE
TITLE:
DIGIT CONVERSION ON DID CALL
76
FUNCTION:
This command is used to assign the data required for interpreting the dialed-in digits.
PRECAUTION:
(1) Digit Conversion on DID call is available when CM35 Y=018 is set to 0.
(2) The first digit in the first data field must be assigned, in CM20 Y=0-3, as a station number 801-808.
(3) When entering data with characters, the following characters can be registered;
Alphabet upper case (A-Z), alphabet lower case (a-z), numeric (0-9), symbol (! “ # $ % & ’ ( ) + ,
; < = > ? @ [ ] ^ _ ‘ { } ~), Space, hyphen (-), period (.), slash (/), colon (:)
NOTE: The character “CCC” cannot be registered.
ASSIGNMENT PROCEDURE:
DATA TABLE:
ST
EXE++ +
+
76YY
2ND DATA
DE
1ST DATA
(1-8 digits) (1-32 digits)
++
DE
: Default
Y
1ST DATA
2ND DATA
REMARKS
No. MEANING DATA MEANING
00 Number Conver-
sion Block No.
for Development
Table 0
X-XXXX:
DID number
000
999
NONE
Number Conversion Block No. 000
Number Conversion Block No. 999
No data
CM35
Y=012, 018,
078, 170
Continued on next page
~
~
APRIL/16/2010
CM76