NEC Univerge SV8300 - [CMEC] MAINTENANCE by Pcpro;Cat

3-681 NWA-033623-001 Rev.8.1
91ch3008.fm
COMMAND CODE
TITLE:
MAINTENANCE BY PCPro/CAT
EC
FUNCTION:
This command is used for maintenance of the PBX. The functions of this command are outlined below:
• Battery release
• Line status display for single line telephone or Multiline Terminal
• Service Information Display
• System data copy from Active CPU to Stand by CPU by manual operation
• System data backup/SDRAM data clear
• System data copy from the Main Unit to Remote Unit
• Day Mode/Night Mode Apply
• Calling party No. Remote Maintenance
PRECAUTION:
(1) See Line Status Display in the following pages for details on how to read the status information.
(2) Line status display of a single line should not be performed while the single line is in use.
(3) Line status display is not available in off-line.
ASSIGNMENT PROCEDURE:
ST EXE++ ++ECY
2ND DATA
DE
1ST DATA
(1-8 digits) (1-16 digits)
++ DE
JANUARY/31/2012
CMEC