NEC Univerge SV8300 - [Cmaa] Dti;Brt;Prt;Cct Blade Functions

3-581 NWA-033623-001 Rev.8.1
91ch3007.fm
COMMAND CODE
TITLE:
DTI/BRT/PRT/CCT BLADE FUNCTIONS
AA
FUNCTION:
This command is used to assign the functions to the DTI, BRT, PRT, and CCT blade.
PRECAUTION:
After setting CMAA Y=00-02, 06, 09, 19-21, 25, the blade reset is required.
ASSIGNMENT PROCEDURE:
DATA TABLE:
+
ST
++
AAYY
++
DATA
DE
EXE
+
TRUNK BLADE NUMBER
(000-127)
DE
(1-2 digits)
: Default
Y SETTING DATA
RELATED
COMMAND
No. MEANING DATA MEANING
00 Data Mode for DTI (T1 1.5 Mbps)/
CCT (T1 1.5 Mbps)
0
1
Based on AT&T Specifications
Not Used
CM05 Y=1
01 Frame Configuration for DTI (T1
1.5 Mbps)/CCT (T1 1.5 Mbps)
0
1
12-Multi Frame (D4)
24-Multi Frame (ESF)
CM05 Y=1
Frame Configuration for DTI (E1
2 Mbps)
[8300R3]
0
1
Double Frame (no CRC-4)
CRC-4 multiframe structure
02 ZCS (Zero Code Suppression) for
CCT (T1 1.5 Mbps)
0
1
Available (Non Transparent)
Not available (Transparent)
CM05 Y=1
NOTE: This data is effective only when the second data of CMAA Y=01 is set to 0 (12-Multi Frame).
Continued on next page
BLADE RESET
BLADE RESET
BLADE RESET
BLADE RESET
JUNE/15/2011
CMAA