NEC Univerge SV8300 - [Cm35] Trunk Route Data

3-286 NWA-033623-001 Rev.8.1
91ch3003.fm
COMMAND CODE
TITLE:
TRUNK ROUTE DATA
35
FUNCTION:
This command is used to assign trunk route characteristics. A trunk route is a group of trunks with com-
mon characteristics used for a common purpose.
PRECAUTION:
(1) When assigning a Tie line, the data in CM35 Y=009 (Incoming connection signaling) should be
similar to that of CM35 Y=020 (Sender starting condition).
The table below shows the assignment of the sender starting condition in relation to the incoming
connection signaling.
NOTE: ( ) indicates the data to be assigned.
INCOMING CONNECTION
SIGNALING (CM35 Y=009)
SENDER START CONDITION
(CM35 Y=020)
REMARKS
Ground Start (01) Ground Start (02)
Loop Start (15) Loop Start (15)
Wink Start (03) Wink Start (00)
Delay Dial (04) Delay Dial (01)
Immediate (05) Timing Start (15)
2nd DT/Timing (06) Timing Start (15)
JULY/17/2009
CM35