NEC Univerge SV8300 - Cat Mode Setting Procedure

Chapter 1 HOW TO USE CAT
1-16 NWA-033623-001 Rev.8.1
91ch1001.fm
CAT MODE SETTING PROCEDURE
CAT MODE SETTING PROCEDURE
To set CAT mode:
• For DT300/DT700 Series/D
term
70 (Elite)/D
term
75 (Series E)/D
term
85 (Series i)
1. Press the Keys on the terminal in the following order when the terminal is on idle state.
2. Press
– “CAT MODE” is displayed on LCD
NOTE: CAT mode is not available when preset dialing on the terminal is restricted (set by CM15
Y=212: 0).
• For D
term
70 (Elite)/D
term
75 (Series E)/D
term
85 (Series i)
1. Press 5. Press
– Conf lamp flashes
2. Press 6. Press
– Conf lamp flashes – Conf, Speaker, Answer lamp on
3. Press – “CAT MODE” is displayed on LCD
– Conf lamp off 7. Press
4. Press – “COMMAND= –” is displayed on LCD
NOTE: Step 1 through 6 need to be completed within 4 seconds.
2286633#
"C" "A" "T" "M" "O" "D" "E"
Hold
Transfer
Conf
Conf
#
*
ST
Transfer
NOVEMBER/12/2008