NEC Univerge SV8300 - [Cm45] Make Busy Condition of Cft;Dtmf Receiver Detect Level

3-389 NWA-033623-001 Rev.8.1
91ch3004.fm
COMMAND CODE
TITLE:
MAKE BUSY CONDITION OF CFT/DTMF RECEIVER DETECT LEVEL
45
FUNCTION:
This command is used to define the make busy condition of built-in CFT on CPU or to set DTMF
Receiver detect level.
PRECAUTION:
None
ASSIGNMENT PROCEDURE:
DATA TABLE:
+ 45Y + + + + +
1ST DATA
2ND DATA
(2-3 digits)
EXE
ST
DEDE
(1-2 digits)
: Default
Y 1ST DATA 2ND DATA
No. MEANING DATA MEANING DATA MEANING
6 Make busy condition
of CFT
[8300R2]
00
15
CPU built-in CFT circuit
number
0
1
Make busy
In service
NOTE 1: Set this data when CPU built-in CFT is secured for Conference.
NOTE 2: Each unit has 16 circuits for built-in CFT on CPU.
NOTE 3: When using Three Party Conference, each group uses one CPU built-in CFT circuits.
NOTE 4: When using Conference, four participants or less can connect to one CPU built-in CFT circuits.
(ex.) Set two circuits to make busy for one 8-party conference.
Continued on next page
~
APRIL/16/2010
CM45