: Default
BASIC SERVICE SETTING DATA
1012 Display Caller ID to my line same as sub line when Automatic
Caller ID to sub line by CM15 Y=224/225 is available
[8300R5]
0
1
Not available
Available
1014 Select the function to override by preset Station dialing/Pro-
grammable key on a Multiline terminal
[8300R5]
0
1
Do Not Disturb (DND), Call For-
warding-All Calls
Do Not Disturb (DND)
NOTE: Preset Station dialing/Programmable key means that the station number is dialed after setting Do Not
Disturb-Override/Call Forwarding-All calls override by Access code/Programmable key.
1017 Select the function to call for Mobility Access station (Dual
Ringing ON) when Mobility Access station or Mobile Phone is
busy
[8300R5]
0
1
Calling an idle station
Hearing Busy Tone
1019 Displaying Icon on the LCD of DT330/DT710 (DESI-less
only)/DT730/DT750
[8300R5]
0
1
Not displayed
To display
1023 Whether to provide Continuous Live Record when Call Hold or
Call Transfer is operated during recording
[8300R6]
0
1
To provide
Not provided
1026 Selection of Mobility Access mode
[8300R6]
0
1
Station Base (8300R6 or later)
Trunk Base (8300R5 or before)
NOTE: When using station service from mobile phone or Enblock Dialing Method (for Forced On PBX), set
this data to 0 (Station base).
1028 Operation for when a mobile phone does a hooking from con-
sultation hold
[8300R7]
0
1
Three Party Conference
Broker’s Call
1029 Operation for when call back to Mobility Access station
[8300R7]
0
1
Mobility Access station and mobile
phone
Mobility Access station
Continued on next page
To Next Page
Loading...
