NEC Univerge SV8300 - Page 157

3-101 NWA-033623-001 Rev.8.1
91ch3001.fm
COMMAND CODE
TITLE:
LAN DATA ASSIGNMENT
0B
Y=1XX
: Default
Y 1ST DATA 2ND DATA
RELATED
COMMAND
No. MEANING
DATA MEANING DATA MEANING
1XX 1 : VOIP Port
XX: Unit No. (01-50)
00 IP Address for the sys-
tem
XXX.XX
...X
NONE
IP Address
(Maximum 15 digits)
XXX.XXX.XXX.XXX=
0.0.0.1-255.255.255.254
No data
NOTE 1: This data cannot be entered by CAT when using 8300R1 software.
NOTE 2: When setting the IP address by this data, a period (.) must be entered
between the numbers (example: 255.255.255.254).
01 Subnet Mask for the
system
XXX.XX
...X
NONE
Subnet Mask
(Maximum 15 digits)
XXX.XXX.XXX.XXX=
255.0.0.0-255.255.255.252
No data
NOTE 1: This data cannot be entered by CAT when using 8300R1 software.
NOTE 2: When setting the Subnet Mask by this data, a period (.) must be entered
between the numbers (example: 255.255.255.252).
02 Default Gateway for the
system
XXX.XX
...X
NONE
Default Gateway
(Maximum 15 digits)
XXX.XXX.XXX.XXX=
0.0.0.1-255.255.255.254
No data
NOTE 1: This data cannot be entered by CAT when using 8300R1 software.
NOTE 2: When setting the Default Gateway by this data, a period (.) must be en-
tered between the numbers (example: 255.255.255.254).
09 Speed mode for the LAN
Interface
02
03
04
05
15
100 Mbps (Full-Duplex)
100 Mbps (Half-Duplex)
10 Mbps (Full-Duplex)
10 Mbps (Half-Duplex)
Auto Negotiation (GbE)
Continued on next page
RESET
RESET
RESET
RESET
APRIL/16/2010
CM0B