NEC Univerge SV8300 - Page 286

3-230 NWA-033623-001 Rev.8.1
91ch3003.fm
COMMAND CODE
TITLE:
NUMBERING PLAN/SINGLE DIGIT FEATURE ACCESS CODE
(PROGRAMMABLE)
20
(3) Name Display Registration From Multiline Terminal is as follows.
• You can configure the station number from the Multiline Terminal to which the station number
belongs.
• Register the characters from PCPro/CAT to SLT, Multiline Terminal without LCD and Trunk.
• The characters are specified by the number of pressing the keys (0-9, *, #).
See “Character Table” on next page.
Example: To register “A”, press key twice.
By pressing same key 11 times, the character returns to the one pressed once.
• To register characters, press key after each character registration.
• To switch between alphabet upper case (A-Z) and alphabet lower case (a-z), press key.
• To delete the data, overwrite by blank.
• The following is the example to register “john”:
(1) (DT receiving)
(2) Register the access code specified for Name Display
(SPDT receiving).
(3)
(4)
(5)
(6)
(7)
Continued on next page
2
Hold
Recall
j
o
h
n
LNR/SPD
5
5
Hold
6
6
6
6
Hold
4
4
4
Hold
6
6
6
Hold
LNR/SPD
JANUARY/14/2011
CM20