: Default
Y SETTING DATA
RELATED
COMMAND
No. MEANING DATA MEANING
02 Terminating system in Day Mode
for incoming C.O. calls
02
03
04
06
08
09
10
11
12
13
14
16
18
21
23
31
Trunk Line (Direct) Appearance
Trunk Line (Direct) Appearance + TAS
Direct-In Termination
Direct-In Termination + Trunk Line
(Direct) Appearance
Dial-in
Automated Attendant
Attendant Console + TAS
[8300R2]
Attendant Console + Trunk Line
(Direct) Appearance
[8300R2]
Attendant Console + Trunk Line
(Direct) Appearance + TAS
[8300R2]
TAS
Attendant Console
[8300R2]
Remote Access to System (DISA)
ISDN Indial
(for receiving maximum 8digits dialed
number)
ISDN Indial
(for receiving complete dialed number)
Enblock Dialing Method
(for Forced On PBX)
[8300R7] [For EU]
DID, Tie Line and the call which is not
handled by the PBX
CM30 Y=18
CM30 Y=04
CM49, CM64
NOTE 1: When data 02, 03, 11 or 12 is assigned, set CM30 Y=18 to 0.
NOTE 2: For DIDs and Tie Lines, set CM30 Y=02 and CM30 Y=03 to 31.
NOTE 3: When data 18 is assigned, the maximum dialed number can be received in ISDN Indial differ with
command as bellow.
- When using CM76 Y=00, the maximum dialed number is 4 digits.
- When using CM76 Y=90, the maximum dialed number is 8 digits.
Continued on next page
To Next Page
Loading...
