Chapter 1 HOW TO USE CAT
1-19 NWA-033623-001 Rev.8.1
91ch1001.fm
NOTICE ON CAT MODE
The following data is automatically set when loading the standard system data.
Command List Set by Standard System Data Assignment
COMMAND
CODE
Y NUMBER 1ST DATA 2ND DATA REMARKS
00 – 1 CCC System Data All Clear
02 CCC SRAM area All Clear
05 0 0101 10 DLC blade registration of Slot No.
01 of Unit No. 01
0B 001 00 192.168.1.1 IP address of Maintenance Port of
Unit No. 01
01 255.255.255.0 Subnet Mask of Maintenance Port of
Unit No. 01
42 3410 UDP port number between active
CPU and Stand by CPU
140 192.168.1.101 IP address of Maintenance Port of
Stand by CPU
002 00 192.168.1.2 IP address of Maintenance Port of
Unit No. 02
01 255.255.255.0 Subnet Mask of Maintenance Port of
Unit No. 02
003 00 192.168.1.3 IP address of Maintenance Port of
Unit No. 03
01 255.255.255.0 Subnet Mask of Maintenance Port of
Unit No. 03
004 00 192.168.1.4 IP address of Maintenance Port of
Unit No. 04
01 255.255.255.0 Subnet Mask of Maintenance Port of
Unit No. 04
Continued on next page
JANUARY/31/2012
To Next Page
Loading...
