: Default
Y SETTING DATA
RELATED
COMMAND
No. MEANING DATA MEANING
076 Designation of Area Code
Development Pattern No. for
Toll Restriction
Analysis, and Maximum
Digit Analysis.
00
07
15
Area Code Development Pattern No. 0
Area Code Development Pattern No. 7
Not used
CM8A
Y=4000-4007
CM85 Y=0-7
078 Number of digits to be
converted on DID for Devel-
opment Table 0
0
1
Leading 2-4 digits
All digits of DID number are converted by
CM76
CM35
Y=012, 018
CM76
079 Terminal connection form
for ISDN Basic Rate
Interface
See PRECAUTION (2)
0
1
Point-to-Point
Point-to-Multipoint
NOTE: Set 0 for BRT blade.
083 Trunk seizure sequence for
an outgoing call
0
1
As per CM08>078
By allotter
CM08>078
CMA7 Y=64
086 Centrex trunk 0
1
To provide
Not provided
087 Distinctive Ringing by
detecting the ringing signal
from main PBX or Centrex
0
1
To provide
Not provided
NOTE 1: When this function is utilized, be sure
to set Trunk Line Appearance as the
terminating method (set by CM30
Y=02, 03: 02).
NOTE 2: Tone Ringer is selected by CM35
Y=034, lamp control is set by CM35
Y=032 respectively.
CM30
Y=02, 03
CM30 Y=18
089 Cyclic Redundancy check-
ing for DTI trunk
See PRECAUTION (2)
0
1
To provide
Not provided
NOTE: This command is not effective when the DTI (E1 2 Mbps) is used (CM05 Y=0: 47). In that case, set
CMAA Y=01.
Continued on next page
To Next Page
Loading...
