: Default
Y SETTING DATA
RELATED
COMMAND
No. MEANING DATA MEANING
257 Specification of the call ter-
minating method for incom-
ing call with no CLI in Night
Mode/Mode A/Mode B
0
1
2
3
To transfer to the VRS/another station/
Attendant Console (assigned by CM51 Y=33)
To reject the call termination
To terminate the Multiline Terminal with
unusual lamp indication (assigned by CM35
Y=258)
To terminate as usual
CM35 Y=256, 258
CM51 Y=33
258 Distinctive lamp indication
on Multiline Terminal for
incoming call with no CLI
0
1
Green (120 IPM)
Red (120 IPM)
CM35
Y=032, 255, 257
NOTE: This command is effective on the following conditions.
• CM35 Y=032 is set to 1.
• CM35 Y=255, 257 are set to 0 or 2, and Multiline Terminal receives the incoming call.
265 Screening Indicator (ISDN
Calling party number)
3
NONE
Network provided
No data
266 Relay of the ALERT mes-
sage to the calling party in
tandem connection (ISDN to
ISDN)
0
1
To provide
Not provided
CM35 Y=233
NOTE 1: This command should be set to both incoming trunk route and outgoing trunk route of tandem office.
NOTE 2: To send tone to the calling party according to the status of calling party (idle or busy) as shown below,
set the second data of CM35 Y=233 and CM35 Y=266 to “0”.
• RBT is sent when the calling party is idle.
• BT is sent when the calling party is busy.
NOTE 3: Set the second data 0 to the incoming and forwarding trunk route of Mobility Access.
267 Coding Type when sending
the ISDN Connected Line
Identification Presentation
(COLP)
[For Spain]
0
1
Codeset 5 (Spanish specification)
Codeset 0 (ETSI specification)
268 Calling Party Name sending
to ISDN
[North America Only]
0
1
To provide
Not provided
Continued on next page
To Next Page
Loading...
