3-377 NWA-033623-001 Rev.8.1
91ch3004.fm
COMMAND CODE
TITLE:
TRUNK RESTRICTION CLASS CONVERSION
42
NOTE 1: Default in the DATA TABLE represents the value for the data “NONE”. In this case, the fol-
lowing conversion is performed in the Deluxe Traveling Class Mark-CCIS.
(1) 2400 IPX to SV8300
2400 IPX SV8300
TRK RESTRICTION CLASS TRK RESTRICTION CLASS
0: OG via ATT 1: Unrestricted (RCA)
1: Unrestricted-1 1: Unrestricted (RCA)
2: Unrestricted-2 2: Non-Restricted-1 (RCB)
3: Non-Restricted 3: Non-Restricted-2 (RCC)
4: Semi-Restricted 4: Semi-Restricted-1 (RCD)
5: Restricted 5: Semi-Restricted-2 (RCE)
6: Fully-Restricted 6: Restricted-1 (RCF)
7: 7: Restricted-2 (RCG)
8: 8: Fully-Restricted (RCH)
15:
(2) SV8300 to 2400 IPX
SV8300 2400 IPX
TRK RESTRICTION CLASS TRK RESTRICTION CLASS
1: Unrestricted (RCA) 1: Unrestricted-1
2: Non-Unrestricted-1 (RCB) 2: Unrestricted-2
3: Non-Restricted-2 (RCC) 3: Non-Restricted
4: Semi-Restricted-1 (RCD) 4: Semi-Restricted
5: Semi-Restricted-2 (RCE) 5: Restricted
6: Restricted-1 (RCF) 6: Fully-Restricted
7: Restricted-2 (RCG) 7:
8: Fully-Restricted (RCH) 8:
NOTE 2: This command should be used when changing the reset setting shown above, or when receiv-
ing the 2400 IPX Trunk Restriction Class (9-15) as a Deluxe Travelling Class Mark.
APRIL/16/2010
CM42
To Next Page
Loading...
