NEC Univerge SV8300 - Page 462

3-406 NWA-033623-001 Rev.8.1
91ch3004.fm
COMMAND CODE
TITLE:
DAY/NIGHT MODE CHANGE BY SYSTEM CLOCK, AUTOMATIC RC/
DND MODE SELECT BY SYSTEM CLOCK
4A
NOTE 1: Automatic Day/Night Mode Change and Automatic RC/DND Mode Select cannot be set for
the same time. Because this command is shared by Automatic Day/Night Mode Change and
Automatic RC/DND Mode Select.
NOTE 2: Only “0” or “5” is available for the last digit number of minute at the 1st data of CM4A
Y=20-27.
When the following last digit number is assigned, the number is corrected and set as follows:
assigned number corrected to
1-4 0
6-9 5
NOTE 3: For the Default Pattern, see the following pages.
Continued on next page
: Default
Y 1ST DATA 2ND DATA
No. MEANING DATA MEANING DATA MEANING
50
51
52
53
54
55
56
57
System Service No. 0
[8300R3]
System Service No. 1
[8300R3]
System Service No. 2
[8300R3]
System Service No. 3
[8300R3]
System Service No. 4
[8300R3]
System Service No. 5
[8300R3]
System Service No. 6
[8300R3]
System Service No. 7
[8300R3]
00
01
Room cut off (RC)
Do not Disturb (DND)
0
1
Set
Reset
90 Default pattern 00-63 Tenant No. 00-63 00
01
02
03
NONE
CCC
Default Pattern No. 0
Default Pattern No. 1
Default Pattern No. 2
Default Pattern No. 3
No data
Data clear
NOTE 3
OFF LINE
JULY/17/2009
CM4A