3-413 NWA-033623-001 Rev.8.1
91ch3005.fm
COMMAND CODE
TITLE:
COMMON ROUTE INDIAL
50
DATA TABLE:
NOTE 2: “C” or “D” should not be assigned as the first digit of an access code to insert a prepause
timing.
Assign the prepause timing by CM41 Y=0>44.
NOTE 3: If “C” is inserted in the access code, it can be used as a pause (1.5 seconds).
To provide the programmable pause, insert “D” instead of “C”.
(Programmable pause; CM41 Y=0>38)
Continued on next page
: Default
Y
KIND OF DATA SETTING DATA
CODE MEANING DATA MEANING
00 0 Two leading digits to be added
NOTE 1: CM35 Y=017 allows digits to be added or
deleted from indialed digit streams on a
route basis.
XX
(2 digits)
NONE
Digits to be added
No data
3 Access Code to be sent out before a Mail Box
number NOTE 2, NOTE 3
XX
XXXX
(2-4 digits)
NONE
Access Code to be sent
out to a VMS
X: 0-9, A (*), B (#), C/D
(Pause)
Not to be sent out
4 Access Code to be sent out after a Mail Box
number NOTE 2, NOTE 3
8 Access Code to be added to the calling station num-
ber when a call is terminated from a station.
This assignment is required to call back from the ana-
log telephone for Caller ID-Station.
[North America Only]
X
XXXX
(1-4 digits)
NONE
Access Code to be added
X: 0-9, A (*), B (#)
No data
JULY/17/2009
CM50
To Next Page
Loading...
