3-438 NWA-033623-001 Rev.8.1
91ch3005.fm
COMMAND CODE
TITLE:
ATT TENANT GROUP, FUNCTIONS
60
NOTE 1: Whether the following equipment can be accommodated to the same DLC blade or not are
depended on CM13 Y=63.
- When the second data of CM13 Y=63 is set to “0”
Accommodatable : DT300/D
term
85/D
term
70/PGD(2)-U10 ADP
Unaccommodatable: D
term
75/DESKCON
- When the second data of CM13 Y=63 is set to “1”
Accommodatable : DT300/D
term
85/D
term
75/DESKCON
Unaccommodatable: D
term
70/PGD(2)-U10 ADP
NOTE 2: A reset by CM60 Y=90>0: 0 is required after this data setting.
NOTE 3: Master ATT must be assigned to a single Attendant Console within the ATT Group.
Continued on next page
: Default
Y GROUP NUMBER
RELATED
COMMAND
No. MEANING DATA MEANING
34 Displaying pattern of Caller ID on
the LCD of DESKCON before
answering or after answering a
trunk call
[8300R2]
0
7
To display calling number on upper
line of LCD, calling name on
middle line of LCD
Not displayed calling number and
calling name simultaneously
35 Tenant number for DESKCON
[8300R2]
00
63
NONE
Tenant No. 00
Tenant No. 63
No data
36 Ringing signal patterns of
DESKCON
[8300R2]
0
1
2
3
0.5ON-0.5OFF
1sON-1sOFF
2sON-4sOFF
1sON-2sOFF
51 DESKCON number for PS-display
[8300R2] NOTE 1
X
XX...XX
NONE
DESKCON No. for PS-display
(1 digit-8 digits)
No data
CM20 Y=0-3: 800
CM60 Y=90
90 DESKCON Soft Reset
[8300R2] NOTE 6, NOTE 7
0
1
To reset
Already reset
CM60 Y=00, 01,
02, 04, 06, 16, 17,
23, 27, 30, 51
CM62
JANUARY/31/2012
CM60
To Next Page
Loading...
