NEC Univerge SV8300 - Page 506

3-450 NWA-033623-001 Rev.8.1
91ch3005.fm
COMMAND CODE
TITLE:
SERVICES ON TENANT BASIS
65
NOTE: CM65 Y=41 is effective only when the second data of CM15 Y=063 is set to 1.
Continued on next page
: Default
Y
TENANT
SETTING DATA
RELATED
COMMAND
No. MEANING DATA MEANING
40 Multiline Terminal ring
frequency
00-63 0
1
See below CM15 Y=83, 84, 93
CM35 Y=034, 164
CM76 Y=23
NOTE: When using D
term
70 (Elite Terminal)/D
term
75 (Series E), or when accommodating D
term
85 (Series
i) in Remote Unit, the second data is fixed to 1.
41 Adding the held call on
Multiline Terminal as a
third party of Three-Way
Calling (Conference
[Three/Four Party]) by
CNF and LINE key oper-
ation
NOTE
00-63 0
1
Allow
Not allowed
CM15 Y=063
Ringer Tone
Pattern No.
Y=40: 0 Y=40: 1
D
term
85
(Series i)/
DT300 Series/
DT700 Series
D
term
70 (Electra Terminal)
D
term
70 (Elite Terminal)/
D
term
75 (Series E)/
D
term
85 (Series i)/
DT300 Series/DT700 Series
1 Ringer Tone 1 480 + 606 [Hz]/
8 [Hz] Modulating Signal
520 + 660 [Hz]/
8 [Hz] Modulating Signal
2 Ringer Tone 2 600 + 700 [Hz]/
16 [Hz] Modulating Signal
660 + 760 [Hz]/
16 [Hz] Modulating Signal
3 Ringer Tone 3 1024 [Hz] Envelop 1100 [Hz] Envelop
4 Ringer Tone 4 500 [Hz] 540 [Hz]
5 Ringer Tone 5 1024 [Hz] 1100 [Hz]
6 Not used 1285 + 1024 [Hz] 1400 + 1100 [Hz]
7 Not used 480 + 606 [Hz]/
16 [Hz] Modulating Signal
520 + 660 [Hz]/
16 [Hz] Modulating Signal
JANUARY/14/2011
CM65