NEC Univerge SV8300 - Page 607

3-551 NWA-033623-001 Rev.8.1
91ch3006.fm
COMMAND CODE
TITLE:
DESKCON KEY ASSIGNMENT
90
NOTE 2: The table below shows the default settings of programmable keys (key No. 07-97) which are
set when DESKCON is set by CM10.
NOTE 3: Only one key assignment is allowed per relay circuit.
Continued on next page
KEY No.
DEFAULT SETTINGS
KEY No.
DEFAULT SETTINGS
SETTING
DATA
MEANING
SETTING
DATA
MEANING
07 F6240 LOOP1 20 – No Data
08 F6241 LOOP2 21 F6150 PAGE0
09 F6242 LOOP3 22 – No Data
10 F6243 LOOP4 23 – No Data
11 F6244 LOOP5 24 F6107 BV
12 F6245 LOOP6 90 F6200 SRC
13 F6000 LDN0 91 F6201 DEST
14 F6040 TIE0 92 – No Data
15 F6064 BUSY 93 F6203 TALK
16 F6060 ATND 94 F6204 HOLD
17 F6063 NANS 95 F6202 CANCEL
18 F6061 RCL 96 F6252 ANSWER
19 – No Data 97 F6253 RELEASE
JULY/17/2009
CM90