: Default
Y 1ST DATA 2ND DATA
RELATED
COMMAND
No. MEANING DATA MEANING DATA MEANING
134 Selection of contact
address after SIP 407-
status
00
31
Profile number
for control
packet
0
1
Ignore “Contact header”
of SIP 407- status
Contact to address of
“Contact header” of SIP
407-status from next
SIP message
CMA7 Y=71
135 Selection of called
number
[8300R3]
0
1
Get called number from
“To header” of INVITE
message
Get called number from
Request-Line of
INVITE message
CMA7 Y=71
CMBA
Y=136
NOTE: This data is effective when CMBA Y=136 is set to “0”.
136 Selection of use the
representative number
as called number or not
[8300R3]
00
31
Profile number
for control
packet
0
1
Not use representative
number as called num-
ber
Use representative num-
ber as called number
CMA7 Y=71
138 SIP trunk Location No.
[8300R5]
00
63
NONE
SIP trunk Location No.
As per CM0B Y=1XX>
10
CMA7 Y=71
NOTE 1: When using T.38 FAX communication, assign the SIP trunk Location No. by this data.
NOTE 2: This data is used for T.38 FAX communication only.
139 Global IP Address of
NAT for Multi-Carrier
Connection
[8300R4]
00
31
Profile number
for control
packet
aaabbb
cccddd
NONE
Global IP Address by
NAT
No data
CMA7 Y=71
CM0B
Y=101>70
NOTE: When single carrier connection service is used, set it by CM0B Y=101>70.
Continued on next page
To Next Page
Loading...
