3-648 NWA-033623-001 Rev.8.1
91ch3008.fm
COMMAND CODE
TITLE:
RESET/INSTANT SYSTEM CHANGEOVER
E0
NOTE 8: For the reset (CME0 Y=5>01) while the system is operating, the call connected to a line via
IPT (P2P CCIS) is not disconnected
NOTE 9: By this command, Active CPU and Stand by CPU are reset, switched and started.
NOTE 10: System data copy should be executed by CMEC Y=5 before System Changeover.
NOTE 11: When Stand by CPU is out of order, “HARD WARE ERROR” is displayed.
NOTE 12: When System Data Backup is being executed in Active CPU, “WAIT, BUSY NOW” is dis-
played.
NOTE 13: When this data is executed for the Stand by CPU under off-line mode, “OK” is displayed
even though System Changeover cannot be executed.
JANUARY/14/2011
CME0
To Next Page
Loading...
