: Default
Y 1ST DATA 2ND DATA
RELATED
COMMAND
No. MEANING
DATA MEANING DATA MEANING
10
59
Unit No. 01-50 01 Destination to receive the
synchronous signal for
DTI/PRT/CCT (First pri-
ority)
01
18
NONE
Slot No.
No data
NOTE 1: Assign this data when the system is a slave office and receives the clock syn-
chronization signal from the master office.
This data assignment is not required when the office is the master office.
NOTE 2: When using the ISDN network, a system must be synchronized to ISDN clocks
for preventing from noise during calling, data transmitting error, and so on.
NOTE 3: This data must be set when using the ISDN network.
02 Destination to receive the
synchronous signal for
DTI/PRT/CCT (Second
priority)
01
18
NONE
Slot No.
No data
NOTE 1: Assign this data when the system is a slave office and receives the clock syn-
chronization signal from the master office.
This data assignment is not required when the office is the master office.
NOTE 2: When using the ISDN network, a system must be synchronized to ISDN clocks
for preventing from noise during calling, data transmitting error, and so on.
05 Maximum number of
channels for Speech syn-
thesis and Voice Response
System
[8300R7]
00
08
NONE
Number of channels for
Speech synthesis
8 channels
NOTE 1: Only Unit No. 01 (Y=10) can be set by this data.
NOTE 2: When CF memory is used for Voice Response System, the number of channels
for Voice Response System (default: 8 channels) is that subtracted the number
of channels for Speech synthesis from the number of simultaneous usable
channels (16 channels).
Continued on next page
To Next Page
Loading...
