PoE Test
Tap the toggle button to enable or disable the
PoE test portion of the current Wired Profile.
Powered Device Class
Tap to select a PoE class setting to match your
switch's (or active PoE injector's) available class.
Product supports these classes:
l
802.3af Classes 0-3
l
802.3at PoE+ Class 4
l
Cisco's UPOE, which can provide up to 51W
l
802.3bt Classes 5-8
Select Passive PoE Injector if you are using a
non-IEEE injector.
NOTE: Product may not receive the total
wattage advertised by your switch or injector
because of power loss over the cable.
NOTE: Product automatically negotiates
Cisco UPOE over LLDP, up to 51W. LLDP
must be enabled on the switch for nego-
tiation to succeed. If the UPOE Class is
selected on your Product but LLDP is not
AutoTest App and Profiles
250
To Next Page
Loading...
