enabled on your Cisco switch, negotiation
fails.
LLDP
This toggle button appears if Class 4 (25.50 W) is
selected. Enable this setting if LLDP is enabled
on the switch you are testing. Class 4 LLDP must
be enabled on the switch for AutoTest to detect
it successfully. If the LLDP setting is enabled but
your switch does not support LLDP, negotiation
fails.
Requested Power (W)
This setting appears if UPOE is selected in the
Powered Device Class setting shown above or if
the Powered Device Class is set to Passive PoE
Injector and TruePower is enabled. Tap to enter
a Requested Power other than the default, if
needed. If you tap the backspace button on the
pop-up number pad and clear the default value,
the valid power range is displayed.
AutoTest App and Profiles
251
To Next Page
Loading...
