EasyManuals Logo

netAlly ETHERSCOPE nXG User Manual

netAlly ETHERSCOPE nXG
820 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #254 background imageLoading...
Page #254 background image
supported by the link partner. You can select a
fixed speed/duplex for the copper interface. For
10 and 100 Mbps you can optionally force the
speed and duplex.
This setting does not force the link speed/duplex
on the fiber interface, but does control which
speed is attempted first when using a multi-rate
SFP. As a result, this setting can enable the test
unit to connect faster via fiber.
Link Persistence
Link Persistence controls product behavior prior
to link and also after link goes down.
Link Persistence and Establishing Link: When
enabled there is no timeout on how long to wait
for link to be established. When disabled, the
link step fail if not successful in 25 to 30
seconds.
Link Persistence and Link Dropping: When
enabled and link drops, the unit attempts to
relink. When disabled and link drops, the profile
is considered done and no further link attempts
are done until a Wired Profile is run again.
AutoTest App and Profiles
254

Table of Contents

Other manuals for netAlly ETHERSCOPE nXG

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the netAlly ETHERSCOPE nXG and is the answer not in the manual?

netAlly ETHERSCOPE nXG Specifications

General IconGeneral
BrandnetAlly
ModelETHERSCOPE nXG
CategoryTest Equipment
LanguageEnglish

Related product manuals