The default setting for Link Persistence is
disabled.
User-Defined MAC
Tap the toggle field to enable a user-defined
MAC for this profile and display the current user-
defined MAC definition:
This setting affects the Wired Test Port only. Tap
the toggle switch to enable a user-defined MAC
address specifically for this profile. When
enabled, an additional User-Defined MAC field
appears under the toggle setting. (If there is no
currently value for this profile, the field shows
the user-defined MACaddress (if any)defined in
the " Wired" on page102 section of the General
Settings. ) Tap the lower field to enter your
desired MAC address for the Product. When this
user-defined MAC is enabled, (User-defined)
AutoTest App and Profiles
255
To Next Page
Loading...
