When capture is running, the capture screen
displays the current file size as data is captured.
Slice Size: Tap this field to select a specific
frame slice size or enter a custom value. The
Slice Size setting limits how much of each
packet is captured. A smaller slice size is useful
when you are interested in the packet’s header
but do not need to see all the payload data. The
default is Full Packet.
Capture Port: Tap to select either the Wired or
Wi-Fi test port.
Wired Filters
All filters are disabled by default unless you
open Capture from another app. Tap the fields
below to enable the filter and enter filter values.
MAC: Enter the MAC address of a host to capture
only packets that contain the host's MAC
address as the source or destination.
IP: Enter the IPv4 or IPv6 address of a host to
capture only traffic to and from the host.
VLAN: Enter a VLAN number to capture only
traffic tagged for that VLAN.
Capture App
405
To Next Page
Loading...
Need help?
General
