Back to Title and Contents
Port: Specify a port number to capture only
traffic from that UDP or TCP port. For example,
select port 80 to capture HTTP traffic only.
NOT: Sets up a logical NOTto use with capture
values you have set up with other filters. For
example, if you set up a filter to capture traffic
to and from IP 10.250.0.70 on Port 80, and then
you enable NOT, the EtherScope nXG Controlled
Edition captures all traffic except traffic to and
from 10.250.0.70 on port 80.
Wi-Fi Filters
Channel: Tap the channel button to set the
channel on which packets are captured.
Channel Width: (Appears only if you select a
Channel number in the 5-GHz or 6-GHz band,
above channel 14). Tap to select a width of 20,
40, 80, or (for 6-GHz band only) 160 MHz.
BSSID/MAC: Enter a BSSID to capture only
packets going to or from the target device.
Control, Data, and Management Frames and
Beacons: All frame types are captured by
default. Tap the toggle button for each frame
type to disable its capture.
Capture App
406
To Next Page
Loading...
Need help?
General
