EasyManuals Logo

NETGEAR D6220 User Manual

NETGEAR D6220
266 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #16 background imageLoading...
Page #16 background image
Connect to the Modem Router
During and after installation, you can connect to the modem router’s network through a wired or WiFi
connection. If you set up your computer to use a static IP address, change the settings of your computer
so that it uses Dynamic Host Configuration Protocol (DHCP).
Connect to the Modem Router Through an Ethernet Cable
You can connect your computer to the modem router using an Ethernet cable and join the modem router’s
local area network (LAN).
To connect your computer to the modem router with an Ethernet cable:
1. Make sure that the modem router is receiving power (its Power LED is lit).
2. Connect an Ethernet cable to an Ethernet port on your computer.
3. Connect the other end of the Ethernet cable to one of the numbered Ethernet ports.
Your computer connects to the local area network (LAN). A message might display on your computer
screen to notify you that an Ethernet cable is connected.
Join the WiFi Network of the Modem Router
Choose either the manual or the WPS method to add a WiFi device such as a WiFi-enabled computer, an
iPhone, an iPad, another mobile device, or a gaming device to the WiFi network of the modem router.
Manual Method
On the WiFi-enabled computer or mobile device that you want to connect to the modem router, you can use
the software application that manages your WiFi connections.
To connect a WiFi-enabled computer or mobile device manually to the WiFi network of the
modem router:
1. Make sure that the modem router is receiving power (its Power LED is lit).
2. On the WiFi-enabled computer or mobile device that you want to connect to your modem router, open
the software application that manages your WiFi connections.
This software scans for all WiFi networks in your area.
3. Look for the modem router’s network and select it.
If you did not change the name of the network during the setup process, look for the default WiFi network
name (SSID) and select it.The default SSID is on the label on the modem router.
4. Enter the modem router WiFi password.
Install and Access the Modem Router and Its Network
16
AC1200 WiFi VDSL/ADSL Modem Router Model D6220

Table of Contents

Other manuals for NETGEAR D6220

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NETGEAR D6220 and is the answer not in the manual?

NETGEAR D6220 Specifications

General IconGeneral
DSL WAN-
Ethernet WANYes
SIM card slotNo
Wi-Fi bandDual-band (2.4 GHz / 5 GHz)
Top Wi-Fi standardWi-Fi 5 (802.11ac)
WLAN data transfer rate (max)900 Mbit/s
Product typeTabletop router
Product colorBlack
Security algorithmsWPA, WPA2, WPA2-PSK
Cabling technology10/100/1000Base-T(X)
Networking standardsIEEE 802.11ac
Ethernet LAN data rates10, 100, 1000 Mbit/s
Ethernet LAN interface typeGigabit Ethernet
USB 2.0 ports quantity1
Ethernet LAN (RJ-45) ports5
Power source typeAC
Routing protocolsIP
Antennas quantity2
Cables includedLAN (RJ-45), Phone (RJ-11)
Weight and Dimensions IconWeight and Dimensions
Depth182 mm
Width240 mm
Height41 mm
Weight341 g

Related product manuals