a. Select either the No or the I don’t know radio button.
b. Click the Next button.
c. Enter the MAC address of the computer or router with which you previously were able to connect
to the Internet.
You might find the MAC address on the product label of your device. Enter the MAC address in
the AABBCCDDEEFF format, not in the AA:BB:CC:DD:EE:FF format.
d. Click the Next button.
20. If the Congratulations! page still does not display and the modem router still does not connect to the
Internet, do the following:
a. Review all your settings and make sure that you selected the correct options and entered everything
correctly.
b. Run the NETGEAR installation assistant one more time.
c. Contact your ISP to verify that you are using the correct configuration information.
d. Read Troubleshoot the Internet Connection on page 254.
e. If problems persist, register your NETGEAR product and contact NETGEAR technical support.
Log In to the Modem Router After Setup to View or Change
Settings
After you set up the modem router for DSL service or cable service, you can view or change the settings
for the modem router.
To log in to the modem router:
1. Launch a web browser from a WiFi-enabled computer or mobile device that is connected to the network.
2. Enter http://www.routerlogin.net.
You can also type http://www.routerlogin.com or http://192.168.0.1.The procedures
in this manual use http://www.routerlogin.net.
Note
Install and Access the Modem Router and Its Network
31
AC1200 WiFi VDSL/ADSL Modem Router Model D6220
To Next Page
Loading...
Need help?
General
Weight and Dimensions
