Name: NETGEAR D6220
Brand: NETGEAR
Rating: 5 (1 reviews)

To Next Page

To Previous Page

7. Click the Add Custom Service button.

8. Specify a new port forwarding rule with a custom service or application as described in the following

table.

DescriptionField

Enter the name of the custom service or application.Service Name

Select the protocol (TCP or UDP) that is associated with the service or application.

If you are unsure, select TCP/UDP.

Service Type

Enter the starting port number for the service or application.External Starting Port

If the service or application uses a single port, enter the same port number in the

External Ending Port field.

If the service or application uses a range of ports, enter the ending port number of the

range in the External Ending Port field.

External Ending Port

Specify the internal ports by one of these methods:

• If the external and internal ports are the same, leave the Use the same port range

for Internal port check box selected.

• If the external and internal ports are different, in the Internal Starting Port field,

enter the starting port number for the service or application.The Internal Ending

Port field is populated automatically.

Internal Starting Port

Internal Ending Port

Either enter an IP address in the Internal IP address field or select the radio button

for an attached device that is listed in the table.

The modem router applies the new rule to the device that you select.

Internal IP address

9. Click the Apply button.

Your settings are saved. The rule is added to the table on the Port Forwarding / Port Triggering page.

Manage Port Forwarding and Port Triggering

240

AC1200 WiFi VDSL/ADSL Modem Router Model D6220

NETGEAR D6220 Specifications

General