NETGEAR M4100 Series User Manual

Configure System Information
109
M4100 Series Managed Switch
6. Click the Login button.
The web management interface menu displays.
7. Select System
 ISDP  Advanced  Global Configuration.
8. Select the Admin Mode Enable radio button.
The default value is Enable.
9. In the T
imer field, specify the period of time between sending new ISDP packets.
The range is 5 to 254 seconds. The default value is 30 seconds.
10. In the Hold T
ime field, specify the hold time for ISDP packets that the switch transmits.
The hold time specifies how long a receiving device should store information sent in the
ISDP packet before discarding it.
The range 10 to 255 seconds. The default value is 180
seconds.
11. Select the Version 2
Advertisements Disable or Enable radio button.
This setting controls the sending of ISDP version 2 packets from the device. The default
value is Enable.
12. Click the APPL
Y button.
Your settings are saved.
The following table describes the ISDP Advanced Global Configuration fields.
Table 33. ISDP Advanced Global Configuration
Field Description
Neighbors table last time changed Displays when the Neighbors table last changed.
Device ID Displays the device ID of this switch.
Device ID format capability Displays the device ID format capability.
Device ID format Displays the device ID format.

NETGEAR M4100 Series Specifications

General

Model	M4100 Series
Switch Type	Managed
Form Factor	Rack-mountable
Port Configuration	24 or 48 ports
Ethernet Ports	10/100/1000 Mbps
PoE Support	Available on some models (PoE and PoE+)
Layer	Layer 2/Layer 3
Management	Web-based, CLI, SNMP
VLAN Support	Yes
QoS	Yes
Stackable	Yes
Ports	24 or 48
Jumbo Frame Support	Yes
Security Features	ACL, 802.1X, RADIUS, TACACS+
Operating Temperature	0° to 50° C (32° to 122° F)
Storage Temperature	-20° to 70° C (-4° to 158° F)
Power Supply	Internal power supply