NETGEAR M4100 Series - Appendix A Default Settings; Factory Default Settings

427
A
A. Default Settings
This appendix describes the default settings for many of the NETGEAR M4100 Managed Switch
software features.
Factory Default Settings
The following table describes the factory default settings for the switch.
Table 106. Factory default settings
Feature Default
IP address 169.254.100.100
Subnet mask 255.255.0.0
Default gateway 0.0.0.0
Protocol DHCP
Management VLAN ID 1
Minimum password length Eight characters
IPv6 management mode Enabled
SNTP client Enabled
SNTP server Not configured
Global logging Enabled
CLI command logging Disabled
Console logging Enabled (Severity level: debug and above)
RAM logging Enabled (Severity level: debug and above)
Persistent (FLASH) logging Disabled
DNS Enabled (No servers configured)
SNMP Enabled (SNMPv1/SNMPv2, SNMP v3)
SNMP Traps Enabled