Maintenance
425
M4100 Series Managed Switch
• Port. Enter the UDP Dest port in probe packets. The initial value is default value. The
port you enter is not retained across a power cycle.
• Size. Enter the size of probe packets. The initial value is default value. The size you
enter is not retained across a power cycle.
10. Click the APPLY button.
The traceroute initiates. The results display in the TraceRoute area.
Configure Traceroute IPv6 Settings
You can tell the switch to send a traceroute request to a specified IP address or host name.
You can use this to discover the paths packets take to a remote destination. Once you click
the APPLY button, the switch sends a traceroute and the results are displayed on the screen.
If a reply to the traceroute is received, the following messages display:
1 a:b:c:d:e:f:g 9869 usec 9775 usec 10584 usec
2 0:0:0:0:0:0:0:0 0 usec * 0 usec * 0 usec *
Hop Count = w Last TTL = z Test attempt = x Test Success = y.
To configure the traceroute IPv6 settings
1. Prepare your computer with a static IP address in the 169.254.100.0 subnet, for
example, 169.254.100.201.
2. Connect an Ethernet cable from an Ethernet port on your computer to an Ethernet port on
the switch.
3. Launch a web browser.
4. Enter the IP address of the switch in the web browser address field.
The default IP address of the switch is 169.254.100.100.
The Login screen displays.
5. Enter the user name and password.
The default admin user name is admin and the default admin password is blank, that is,
do not enter a password.
6. Click the Login button.
The web management interface menu displays.
To Next Page
Loading...
Need help?
General
