NETGEAR M4100 Series User Manual

Configure System Information
79
M4100 Series Managed Switch
The Unit list displays the current PoE unit.
8. T
o change the PoE unit, select another unit from the menu.
9. In the System Usage Threshold field, enter a number from 1 to 99.
This sets the threshold level at which a trap is sent if consumed power is greater than the
threshold power
.
10. Select the Power Management Mode Dynamic or Static radio button.
This setting describes or controls the power management algorithm used by the PSE to
deliver power to the requesting PDs.
• Dynamic.
The power consumption on each port is measured and calculated in real
time.
• Static.
The power allocated for each port depends on the type of power threshold
configured on the port.
11. Select the
Traps Enable or Disable radio button.
Enable activates the PoE traps. Disable deactivates the PoE traps. The default setting is
enabled.
12. Click the APPL
Y button.
The updated configuration is sent to the switch. Configuration changes take effect
immediately
.

NETGEAR M4100 Series Specifications

General

Model	M4100 Series
Switch Type	Managed
Form Factor	Rack-mountable
Port Configuration	24 or 48 ports
Ethernet Ports	10/100/1000 Mbps
PoE Support	Available on some models (PoE and PoE+)
Layer	Layer 2/Layer 3
Management	Web-based, CLI, SNMP
VLAN Support	Yes
QoS	Yes
Stackable	Yes
Ports	24 or 48
Jumbo Frame Support	Yes
Security Features	ACL, 802.1X, RADIUS, TACACS+
Operating Temperature	0° to 50° C (32° to 122° F)
Storage Temperature	-20° to 70° C (-4° to 158° F)
Power Supply	Internal power supply