Configure System Information
89
M4100 Series Managed Switch
The default IP address of the switch is 169.254.100.100.
The Login screen displays.
5. Enter the user name and password.
The default admin user name is admin and the default admin password is blank, that is,
do not enter a password.
6. Click the Login button.
The web management interface menu displays.
7. Select System
SNMP SNMP V3 User Configuration.
8. Use User Name to specify the user account to be configured.
9. Select the SNMP v3
Access Mode.
This indicates the SNMP v3 access privileges for the user account. The admin account
always has Read/W
rite access, and all other accounts use Read Only access.
10. Use Authentication Protocol to specify the SNMP v3 Authentication Protocol setting for
the selected user account. The valid Authentication Protocols are None, MD5 or SHA:
• If you select None, the user cannot access the SNMP data from an SNMP browser
.
• If you select MD5 or SHA, the user login password are used as the SNMP v3
authentication password, and you must therefore specify a password, and it must be
eight characters long.
11. Use Encryption Protocol to specify the SNMP v3 Encryption Protocol setting for the
selected user account.
The valid Encryption Protocols are None or DES:
• If you select the DES Protocol, you must enter a key in the Encryption Key field.
• If None is specified for the Protocol, the Encryption Key is ignored.
12. Enter the Encryption Key.
If you selected DES in the Encryption Protocol field, enter the SNMP v3 Encryption Key
here; otherwise, this field is ignored. V
alid keys are 0 to 15 characters long. The APPLY
check box must be selected for you to change the Encryption Protocol and Encryption
Key.
13. Click the APPL
Y button.
The updated configuration is sent to the switch. Configuration changes take effect
immediately
.
To Next Page
Loading...
Need help?
General
