Safety
information
Product
information
Mechanical
installation
Electrical
installation
Getting
started
Basic
parameters
Running the
motor
Optimization
NV Media Card
Operation
Building
Automation
Advanced
parameters
Technical
data
Diagnostics
UL listing
information
HVAC Drive H300 29
Issue Number: 3
Figure 3-7 Removing the size 5 terminal covers
1. Control terminal cover
2. DC cover
On size 5 drives, the Control terminal cover must be removed before removal of the DC / Terminal cover right. When replacing the terminal covers,
the screws should be tightened to a maximum torque of 1 N m (0.7 lb ft).
Figure 3-8 Removing the size 6 terminal covers
To Next Page
Loading...
