Safety
information
Product
information
Mechanical
installation
Electrical
installation
Getting
started
Basic
parameters
Running the
motor
Optimization
NV Media Card
Operation
Building
Automation
Advanced
parameters
Technical
data
Diagnostics
UL listing
information
HVAC Drive H300 33
Issue Number: 3
Figure 3-13 Removal of a standard option module
• Press down on the tab (1) to release the option module from the drive housing, the tab is highlighted in the detailed view (A).
• Tilt the option module towards you as shown (2).
• Totally remove the option module in direction shown (3).
Figure 3-14 Installation and removal of the KI-Keypad
To install, align the keypad and press gently in the direction shown until it clicks into position.
To remove, reverse the installation instructions.
N
The keypad can be installed / removed while the drive is powered up and running a motor, providing that the drive is not operating in keypad mode.
To Next Page
Loading...
