Nidec H300 - Size 6 Auxiliary (Capacitor Bank) Fan Replacement

Safety
information
Product
information
Mechanical
installation
Electrical
installation
Getting
started
Basic
parameters
Running the
motor
Optimization
NV Media Card
Operation
Building
Automation
Advanced
parameters
Technical
data
Diagnostics
UL listing
information
HVAC Drive H300 73
Issue Number: 3
3.13.7 Size 6 auxiliary (capacitor bank) fan replacement
Figure 3-63 Removal of the size 6 auxiliary(capacitor bank) fan
• Press the tabs (1) inwards to release the fan assembly from the drive mid cover.
• Use the tabs (1) to withdraw the fan from the drive by pulling the fan assembly forward and tilting it at a slight angle (2).
• Pull the fan assembly up and away from the drive (3).
• Depress and hold the locking release on the fan cable lead.
• With the locking release depressed, take hold of the fan supply cable and carefully pull to separate the connectors.
Replace the fan by reversing the above instructions.
Table 3-28 Size 6 auxiliary fan part number
1
2
3
Model Auxiliary fan part number
Size 6 3251-0030