Installation
3-2
Part 1602966−05
E 2015 Nordson Corporation
Lift Cylinder Installation
See Figure 3-13. The lift cylinder may be removed for shipping. Follow this
procedure to install it if necessary.
1. Remove the lift cylinder packaging and inspect it for damage. Three
proximity switches should be installed in the grooves along the cylinder
body.
2. Unsnap the clevis pin clip from the clevis and remove the pin.
3. Remove the four M8 x 75 screws from the bottom of each side of the
bearing block and lift off the bearing caps.
4. Remove the bearings from the bearing caps. Install the bearings on the
cylinder trunnions, with the bearing flanges toward the cylinder.
5. Install the cylinder through the square opening in the roof of the feed
center, then carefully guide the bearings into the bearing block.
6. Install the bearing caps on top of the bearings, and secure the caps with
the four M8 x 75 screws.
7. Connect the clevis to the lance carriage with the clevis pin and snap the
pin clip around the clevis.
8. Connect air tubing to the cylinder:
S 6-mm tubing from the down regulator to the upper flow control valve.
S 6-mm tubing from the up regulator to the lower flow control valve.
S 6-mm tubing from solenoid #3 SOL326 to the cylinder lock.
9. If removed, install the proximity switches on the cylinder as shown.
S LS306: Hopper position
S LS307: Box position
S LS308: Purge position
10. When the feed center installation is complete, adjust the proximity switch
positions as described on page 3-11.
To Next Page
Loading...
Need help?
General
