EasyManuals Logo

Nordson Encore Customer Product Manual

Nordson Encore
139 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #61 background imageLoading...
Page #61 background image
Operation
5-7
Part 160296605
E 2015 Nordson Corporation
Color Change Procedure
Refer to the Color Change Procedure included with your system manual for
instructions on color changing a powder coating system with a ColorMax
booth and this Encore Venturi Feed Center.
During a color change sequence, the lances are withdrawn from the powder
source, then lowered onto the purge manifold. High pressure air is directed
through the lances, pumps, feed hoses, and guns, purging them of powder.
The reclaim and virgin transfer pumps are also purged. The operator
cleans the sieve, lances, and the interior of the booth, and readies the feed
center for the next color. Meanwhile, another operator cleans the booth and
cyclone.
The recommended sequence of steps is provided in the color change charts
furnished by Nordson, but can be modified as desired depending on the
customer needs and requirements.
Shutdown
1. Move the system offline, if applicable.
2. Clean the system by performing the color change process, but do not
install a new powder source or turn the pumps, sieve, or vibratory table
on.
3. If you will be shutting down the powder feed center for maintenance,
repair, or an extended period of time, perform these steps:
d. Press the SYSTEM STOP button on the system control panel.
e. Turn the electrical disconnect switch on the powder feed center
control panel to the OFF position.

Table of Contents

Other manuals for Nordson Encore

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Nordson Encore and is the answer not in the manual?

Nordson Encore Specifications

General IconGeneral
BrandNordson
ModelEncore
CategoryPaint Sprayer
LanguageEnglish

Related product manuals