Setup
4-3
Part 1602966−05
E 2015 Nordson Corporation
Changing Function Values
Swing down the control panel door to access the PLC.
NOTE: These instructions are also reproduced on a label on the inside the
control panel door.
Figure 4-26 Feed Center PLC Interface
1. Press the ESC key to begin search mode.
2. Find the function screen to be changed by pressing the UP (Y) or
DOWN (B) arrow keys.
3. While on the selected screen, press and hold the ESC key. A cursor will
appear.
4. Use the LEFT (A) and RIGHT (") arrow keys to position the cursor on
the value to be changed.
5. Press the OK key to highlight the value.
6. Use the LEFT (A) and RIGHT (") arrow keys to select the correct units
(xx:xx) column, and then the UP (Y) and DOWN (B) arrow keys to
change the value.
7. Press the the OK key to enter the value.
8. Make additional changes to the same page by moving the cursor as
described in steps 4−7.
9. When data changes to the page are complete, press the ESC key twice.
To Next Page
Loading...
Need help?
General
