NTI ENVIROMUX Series User Manual

NTI ENTERPRISE ENVIRONMENT MONITORING SYSTEM
135
4. Locate the date/time battery in the ENVIROMUX (see images above).
5. Using a non-conductive
stick-like object (ex. a Q-tip with the cotton removed from one end), press the battery out of the
battery holder. Be careful not to let it fall onto the circuit board if you are doing this with power ON.
In E-16D – apply pressure to edge of
battery as shown, pressing the battery
against the spring…..
…..compress spring until
clip is cleared……
spring
…then tilt the battery up to
remove it.
In E-5D – apply pressure to edge of
battery as shown, …..
… pressing the battery out from under
the retaining clip.
retaining clip
E-16D Battery
R
emoval
E-5
D
Battery
R
emoval

NTI ENVIROMUX Series Specifications

General

Product Type	Environmental Monitoring System
Temperature Range	-40°C to 85°C
Power Supply	12V DC or 24V AC
Network Interface	Ethernet 10/100 Mbps
Alarm Notifications	Email, SNMP
Sensor Types Supported	Temperature, Humidity, Water, Airflow
Power	12V DC or 24V AC
Operating Temperature	-40°C to 85°C
Mounting	Wall or Rack Mount
Communication Interfaces	Ethernet
Data Logging	Yes
Compliance	CE, RoHS