Oki Pro1040 - Page 105

- 105 -
Adjusting Color with the Control Panel
(2)
Select [Calibration], and press the
<OK> button.
(3)
Select [Base Color Tuning], and
press the <OK> button.
(4)
Specify the number of the desired
square in the "Highlight" area of
the pattern, and then press the
<OK> button.
(5)
Specify the number of the desired
square in the "Mid-Tone" area of
the pattern, and then press the
<OK> button.
(6)
Specify the number of the desired
square in the "Dark" area of the
pattern, and then press the <OK>
button.
(7)
The pattern number specified in
each area will be displayed.
If the pattern number is correct,
select [Yes], and press the <OK>
button.
Memo
z
To respecify the pattern number select [No] to
return to the "Calibration" screen.
(8)
Select [Return], and press the
<OK> button to return to the
standby screen.
Memo
z
If the desired color balance is not obtained even
after [Base Color Tuning], adjust the CMY color
balance manually using the procedure under
[Adjusting the color balance]. For color balance
fine tuning, see “Fine-tuning Color Balance”
(P.106).
z
If the overall tone is still too bright or too dark
even after implementing [Base Color Tuning],
adjust the black tone manually using [Fine
Color Tuning], and then implement [Basic color
Tuning] again. To brighten the overall tone,
adjust the black tone in [Fine Color Tuning] in
the - direction, and to darken the overall tone,
adjust the black tone in [Fine Color Tuning] in
the + direction.