- 102 -
Adjusting Color with the Control Panel
5
The display will return to the standby
screen after density adjustment is
complete.
Fine Tuning Density
Adjustments
You can finely adjust the densities of colors
that are used as the references for density
compensation.
Adjust each color separately for the parts where
the density is noticeable from the print results.
This section describes the procedure for
adjusting the reference density for cyan. Use the
same adjustment procedure also for other colors
that you wish to adjust.
z
Increasing cyan after checking the print
results
1
Press the <Fn> key.
The numerical values input screen will
be displayed.
2
Press <3>, <1>, <0>, and press the
<OK> button.
Memo
z
For magenta, yellow, black, and white*, use the
operations below.
- To tune magenta, press the <Fn> key, and then
press the following buttons: <3>, <1>, <1>,
<OK>.
- To tune yellow, press the <Fn> key, and then
press the following buttons: <3>, <1>, <2>,
<OK>.
- To tune black, press the <Fn> key, and then press
the following buttons: <3>, <1>, <3>, <OK>.
- To tune white*, press the <Fn> key, and then
press the following buttons: <3>, <1>, <4>,
<OK>.
*: Can be adjusted on the Pro1050 only
To Next Page
Loading...
