- 78 -
Table of Setting Items in the Control Panel Menu Screen
[Boot Menu]
Note
z
This menu is displayed in English only.
Boot Menu
Note
z
To enter this menu, press and hold the <OK> button while turning ON the power supply.
z
Confirm that [Boot Menu] is selected and then press the <OK> button.
z
To enter this menu, it is necessary to enter the [Password].
z
The factory default setting of the administrator password is [999999].
z
Shaded areas are factory-set values.
Item Value Description
Storage
Common
Setup
Check File System Execute Executes management data (FAT information)
recovery, and resolves mismatches between the
actual (free) space in the file system and the
displayed free space.
Check All Sectors Execute Recovers defective sector information on the HDD
and file system nonconformances.
Menu Lockout On
Off
Specifies whether or not to display menus on the
control panel.
Panel Lockout Mode1
Mode2
Off
Sets whether to disable the operations buttons on
the control panel.
Troubleshooting
Note
z
To enter this menu, press and hold the <OK> button while turning ON the power supply.
z
Select [Troubleshooting] and then press the <OK> button.
Item Value Description
Sensor Calibration Reset Execute This resets all sensor calibration results to initial
values.
To Next Page
Loading...
