- 154 -
Using a Web Browser to Configure the Network Setup
Logging in as an
Administrator
Note
z
To change printer settings using a web browser, you need
to log in as a printer administrator.
1
Click [Administrator Login].
2
For [Username] enter "root", for
[Password] enter the current password,
and then click [OK].
Memo
z
The password is the same as the control panel
"Administrator Password".
3
Specify the configuration information
that can be checked on the network,
and then click [OK] or [SKIP].
Note
z
You can skip configuring settings by clicking [SKIP].
z
Selecting the [Do not show this page again]
checkbox, and then clicking [OK] or [SKIP] will
cause this page not to be displayed any more.
4
This will display the screen below.